Once you learn how to use the MPLS hammer, you'll suddenly see a million nails you could whack with your shiny new hammer !

We deployed MPLS and MPLS Layer3 VPNs on the IU campus network this past Monday morning. It was VERY anticlimactic ! We cut and pasted some relatively minimal configs into the routers and it all just worked. What is probably the single largest change in how we do networking on campus since the advent of VLANs happened with no one noticing (except Damon and I who were up entirely too early for a Monday morning). Of course, under the covers all kinds of fancy stuff is happening and we now have a powerful new tool in our tool chest !

Weeks before we actually configured the first MPLS VPN on the network (btw- we won't be putting a production system into this MPLS VPN until Dec. 2nd), we already planned to make MPLS VPNs the centerpiece of the network for the new data center in Bloomington ! Your first thought is probably, why the heck would we want MPLS VPNs in the data center network ?

Our current data center network design has "end-of-row" or "zone" switches (layer-2 only) with cat6 cables running to servers in the adjacent racks. The zone switches each have a 10GbE uplink into a distribution switch (again, layer-2 only). The distribution switch has an 802.1q trunk (2x 10GbE) into the core router. This .1q trunk between the distribution switch and the core router has a Juniper firewall in the middle of it - running in layer-2 mode. Those of you who know this setup in detail will know this is not exactly correct and is over-simplified, but the point is the same.

One problem with this design is that, with over 30 VLANs in the machine room, there is a lot of traffic going in and out of the firewall just to get between 2 VLANs in the same room - perhaps between 2 servers in the same row or same rack or 2 virtual servers inside the same physical server. This causes a couple of problems:

1) It adds significant extra load on the firewall unnecessarily in many cases. Think about DNS queries from all those servers...
2) It makes it very difficult to do vulnerability scanning from behind the firewall because the scanners have to be on 30+ different VLANs

The solution to "fix" this is to place a router behind the firewall - ie turn the distribution switch into a layer-3 routing switch. However, if we did this all 30+ VLANs would be in the same security "zone" - ie there would be no firewall between any of the servers in the machine room. This is not good either. For one, we offer a colocation service and virtual server services, so there are many servers that do no belong to UITS. So we don't want those in the same security zone as our critical central systems. It's probably also not a good idea to put servers with sensitive data in the same security zone as say our FTP mirror server. One solution then would be to place a router behind the firewall for each security zone. But of course that gets very expensive....if you want 5 security zones you need 10 routers (redundant routers for each zone).

And this is where the MPLS VPN hammer gets pulled out to plunk this nail on the head !! You use MPLS VPNs to put 5 virtual routers on each physical router and put a firewall between each virtual router and the physical router and your problem is solved. And actually, if you can virtualize the firewall, you can create a virtual firewall for each virtual router and you have 5 completely separate security zones with a pair of high-end routers and firewalls supporting all 5 - all for no extra cost *except* for all the added operational complexity. Those are the costs we need to figure out before we go too crazy whacking nails with our shiny new hammer !!